TYPE EVOBOND W-50

DESCRIPTION EVOBOND W-50 is a low viscosity quick setting velocity ethyl
cyanoacrylate adhesive.

APPLICATION Ideal for bonding plastics, rubber, metal.

CURE SPEED

Plastic : 10 – 40 seconds
Rubber : 10 – 40 seconds
Metal :
10 – 40 seconds
Wood :
10 – 40 seconds
(22 , 50% relative humidity ASTM D1002, 0.1 N/mm2 tensile shear strength)

GENERAL PROPERTIES
Uncured monomer
Main Component
Appearance
Specific gravity, 25
Viscosity 25 (CPS)
Capillary Viscometers
#200 P378@20
Flash point
Shelf life (20 ) month
(Stored in cool & dry place, unopened
bottle & out of direct sunlight)

Ethyl Cyanoacrylate
Clear liquid
1.04
1.5-5.0 CPS

>80
12

Cured Adhesive
Gap Filling
Tensile Strength
steel – steel ASTM D-2095
Tensile shear Strength
steel/steel ASTM D-1002
Service Temperature Range
Full cure time

10 ~ 20 N/mm2

PRODUCT SIZES

20g, 50g, 500g, 1kg, 2kg, 20kg, 200kg

SAFTY DIRECTION

Danger, irritant
Avoid contact with eyes and skin, bonds skin in seconds. In case of eye
contact, flush with plenty water for over 15 minutes, call a physician
immediately. Use in well-ventilated place. Avoid contact clothing, it can
cause very strong heat.

APPLICATION DIRECTION

0.04 mm
10 ~ 20 N/mm2

-55 ~ 82
24 hours

The surfaces to be bonded should be clean and free of grease completely.
Excess Adhesive can be treated by EVOBOND Debonder AD-1 or
acetone.
If setting time is too long due to large gaps or low relative humidity.
EVOBOND Accelerator AF-1 can be used.
If the porosity of surface is higher, higher viscosity type should be better.
Difficult to bond plastics, like PE, PP, Silicone Rubber, ABS, TPR,
EPDM’s Adhesion, EVOBOND Primer (AP-1) should be applied firstly,
then applied EVOBOND super glue.